High Power REVO subs are recommended for applications where there is adequate room for a specifically designed sealed or ported subwoofer enclosure.  Full specifications to design enclosures for REVO HP  Subs are available at www.wetsounds.com. Both 10” & 12” REVO HP Subs are available in Black frames (with metallic grey cones) & single 4 Ohm impedance.

 

All REVO 10” & 12” Subwoofers share the same design features: 

  • Powder Coated Cast Aluminum Frame – to withstand extreme environmental use.  Designed to accept optional RGB wiring.
  • Injection Molded Composite Cone – For durability & low distortion.
  • Santoprene Rubber Spider – Much more durable to water & temperature changes than a traditional treated Cotton Spider used by the majority of marine speakers & subwoofers.
  • Santoprene Rubber Surround – Offers a superior bond to the composite cone.  Also resists deterioration due to water, temperature & ultraviolet exposure.
  • Gold Plated Terminals – Designed to resist corrosion.

 

All REVO Subwoofers are sold without grills.  8 different grill designs are available separately for all versions of 10” & 12” REVO HP & FA subwoofers.  This will enable users to have matching grills on both REVO Coaxial In-Boat speakers & REVO Subwoofers.

Optional RGB LED Kits are available to fit under all REVO 10” & 12” subwoofer grills to enable users to have thousands of LED light display combinations.

Specifications:

Impedance:    4 ohms

RMS Watts:    500
PEAK Watts:    1000
Frequency Response:    20Hz to 400HZ
Sensitivity:    88 db at 1watt/1 meter
Weight:    17.6 lbs (7.98 kg)

Diameter:    12.6 inches w/grill (320.04 mm)     
Mounting Depth:    4.92 inches (124.96 mm)     
Hole Cut Out:    11.26 inches (286.0 mm)     
Box Specs    Min 1.1 cu ft sealed enclosure or 1.7 cu ft ported     
Note:    All specifications are for each REVO12HPSW

Wet Sounds REVO-12HP Marine Subwoofer